How to establish the connection between Android phone and Q-68HR ?

A .Please follow the procedures below. Check if the Android version of your phone is Android 4.3 above, and if it does support Bluetooth 4.0 Low Energy? You may refer to here to see more compatible devices.

To determine what version is running on your device, select "Settings > About Device".


B. After you checked above, please follow the instructions below to wear the Q-68HR and connect with i-gotU Life app:

(1). Please download and install i-gotU Life app on your phone:

Please ensure that you have correctly worn the Q-68HR . Please refer to the user manual to help you wear correctly.
Q-68HR online user manual:

(2). After wearing your Q-68HR , please open i-gotU Life app and click "Yes. First time" to start the installation.
If you have installed this Q-68HR with any other phone before, please click "No, Not first time" .

(3). Please notice that: Please make sure your Q-68HR is fully charged when used for the first time.
It takes about 3 hours before it is fully charged. If you have not done that, Q-68HR would not be started normally.
If you select "Yes, Fist time", please click "NEXT" button, and skip to Step(4).

If you select "No, Not first time", please continue to do "Check Device Status" and "Reset Device Settings".

[Check Device Status]
Please switch Q-68HR to Daily mode, and make sure the signal strength icon does not appear.
Please tap "here" if the signal strength icon appears.

[Reset Device Settings]
Reset your Q-68HR device, please refer to the link below. .

(4). If you have not turn on your phone Bluetooth function, it will ask you to turn it on. Please tap "Allow".

(5). After turning on Bluetooth, i-gotU Life will start to search your Q-68HR .

If your phone Bluetooth cannot search Q-68HR , please try the followings:
1. If your Android version is v6.0.x, please enable the Location service(GPS).
2. Please tap the Q-68HR button twice and then back to App and scan again.

(6). When searching your Q-68HR , please tap on it. It will be connected automatically.

(7). Please press the button of your Q-68HR twice in 30 seconds in order to confirm the connection of the device.

(8). Now, Q-68HR is connected. Please tap "NEXT".

(9). You have to input the correct personal information, or it will not analyze your sport data accurately.

(10). i-gotU Life will auto-detect the firmware version of Q-68HR , please click "NEXT" to upgrade to the latest version.
Q-68HR will connect to server and check the firmware version when the Q-68HR has first connected with phone successfully, please make sure Wi-Fi or 3G network of your phone has been turned on.

(11). When upgrading the firmware, it needs to take around 10~15 minutes. Please be patient to wait and not to close the app.

(12). If you would like to transfer the notification from phone to your Q-68HR , please click "Settings" to enable the Notification function.

(13). Q-68HR is set up successfully. Please tap "Complete" and continue to practice the mode switching, please follow the steps to practice, and tap "Exit" to go back to main page.

The program will go into the main page of the app, it will show "Connected" on the left top.
You can start to use i-gotU Life.